|
The only thing I can suggest is to use slightly thicker multistranded wire for the power and ground, Then flash up the PS2 in bits i.e just motherboard, power supply board and dvd drive on an insulated surface and get a multimeter across the 3.45 volt and ground connections on the messiah 2 and check that the voltage is actually getting there.
It's a bit tricky getting it plugged up together without a shield around the board or a case but can be done ( I've done it).
You'll need lots of none conductive stuff to prop things on, U should just need motherboard, power board, DVD Drive and reset/eject button assembly.
Good luck.
__________________
Zap Brannigan quote - "You remind me of a younger me Fry, Not much younger mind, perhaps even a little older."
|
19-03-2003, 14:08
Hybrid Mode
