XTool 2020 (Main Project)

[github]

Thank you for the example.

I have it setup up like this

;zlib zstd,oodle,reflate,preflate
;calling example: xtool:mzlib or xtool:mzlib:c128m:t100p-1 not xtool:mzlib+zstd
[External compressor:xtool]
header = 0
default = -c128m -t100p-1
packcmd = "pre\XTool_2020\XTool" precomp {options} - - <stdin> <stdout>
unpackcmd= "pre\XTool_2020\XTool" decode:t4 - - <stdin> <stdout>

; calling example zlib:c128m:t100p-1
[External compressor:zlib,zstd,oodle,reflate,preflate]
header = 0
default = -c128m -t100p-1
packcmd = "pre\XTool_2020\XTool" precomp -m{compressor} {options} - - <stdin> <stdout>
unpackcmd= "pre\XTool_2020\XTool" decode:t4 - - <stdin> <stdout>

However both setups can not to pass in like xtool:mzlib+zstd since + is parsed by freearc, but I guess it's rarely needed to pass in to methods.

I asked about passing in the -d option, since there are up to 10, just saying to test it so I used 3 or 5, and in my case I do need to use -d3 or -d5 to get the same result as xtool 0.12