I am definately struggling...Please Help

[Sublime_4_Life]

ok guys i just got my chip in the mail and installed in my xbox...

SPECS - vrs 1.1 xbox, xecuter 2.3b lite modchip, wire install

So here we go...I got the chip installed and everything seemed to be alright but i have some questions. When i start up my box i have the settings on ENABLE, BANK 1, UNPROTECTED (for future reference i have tried all combinations) The 2 led's on the chip shine blue and the green led on the switch is on...The xbox starts up...green, then orange, then green, flashes green 4 times and is then loaded to what im guessing is the bios.

It shows FlashBIOS (Cromwell 2.28 dev) on the screen and then my dvd tray ejects (all the tutorials say this is exactely what is supposed to happen)

Since there is already a bios on the chip i decided i would just burn the evolution x dashboard on a dvdr to load that. Well i followed the tutorials and created the iso with xiso with the files (evox.ini, default.xbe, bios folder, and skin folder) So i close the tray and it starts to load the disc, well then it says "No Bios update found...Halting" Well i thought i was installing the dashboard, not the bios, since my chip comes preflashed anyways (right?) So im not exactely sure what is goin on here (i am using the EvolutionX build 3935 with the M7 bios in the folder) Any Ideas on what is wrong?

Also, when i set my chip to disable, the led on the external switch stays red and my box tries to boot 3 times then FRAGs. This just seems wierd that it does that when it is DISABLED...i went back and checked all my solder connections and cannot see anything wrong with them..also i used the alternate D0 point on the underside since the top point was not working for me at all..no one has had a problem with doing that have you?

Sorry for such a long post but i have been reading for the last few hours and cant seem to figure out what is wrong with my xbox. Thanks to anyone that can help me out