|
#6
09-05-2004, 20:37
|
||||
|
||||
|
I use the flat edge of a razor - not the point - and just gently drag it across / along the trace.
you could practice doing this on the ground plane on other areas or on say a dead bit of electronics first - as the traces are very thin.
__________________
[size=4][B][color=BLACK]ShadowKnyght[/size][/color] [color=purple]Electronic Engineer[/color][/B] [url=http://www.cyber-mag.com/station/ps2tips.htm][color=darkgreen]Tools, tips & suggestions[/color][/url] [url=http://www.cyber-mag.com/station/laser.html][color=red]Laser adjust & clean guide[/color][/url] 
|
|
|
Threaded Mode