Apple Pro caused loss of browser??

[kiwipom]

Hi

After reading many threads and advice here i went for the new apple pro.

PROBLEM!!-

v7 PAL SCH39002

I had a clean install - anti static, low wattage solder iron - .25mm enamelled copper (approx 30awg) and 24 AWG power, etc etc.. but have now lost the start up browser - ie no 'floating electrons' and no sound. Removed the chip - still the same

Checked the AV leads, checked motherboard fuses (1-15??) continuity fine on all

Legs on soldering area C (http://www.apple-chip.com/index/applepro.html) all clear (continuity between 11 &13 but circuit board routes this way?) The only difference i did notice to this diagram was this chip (which does??BIOS??) had all legs whereas on my v7 legs 13,14,15 and the opposite side are just soldered pads on the board and no leg comes down from the chip.

RESET light and EJECT functions work, tray ejects, disc skips around when loaded for a good 10-15 secs.

ANY SUGGESTIONS as I have a queue of people after this mod here in NZ