Xecuter 2 lite, Evo-x, NEED HELP!!!!

[infidelity]

I installed the Xecuter 2 lite chip into my xbox. I soldered all the wires needed to run the chip, (even that nasty grey "do" wire)
Now, before all of this, I had the enigmah chip installed, with evox dash installed. Thre reason why I'm switching chips, is because I'm putting in an 80 gig Maxtor HDD. Now, I've already made a backup of my previous HDD onto my pc, and have switched HDD's from my xbox. And I have the Xecuter 2 lite chip installed (I did not install the pogo pins)

Now, I believe I have made the correct connections, cause when I booted up my xbox, all of a sudden this screen appeared, + no flashing red lights!! Here's what the screen says......

Xbox Linux Clean BIOS 1.8

Jan 21 2003 - http://xbox-linux.sf.net
(C)2002 Xbox Linux Team - Licensed under the GPL

hda: Maxtor 6Y080P0 81.964GB -No FATX -No MBR
hdx: THOMSON-DVD
UDMA2

Settings mode not done yet :-)
Please reboot and try again

Now, at the bottom of the screen there are 4 icons, 2 of which are shadowed over, the other 2 icons, are a pic of a CD, and a Chip. I tried putting in my evox installation disk, it would'nt accept it. I even tried making a bootable cd with the ozxflash.iso, (which was recommended by the xecuter chip web site) still nothing. The Xecuter site said that the lite chips needed to be reflashed with the BIOS of your choice. But I can't reflash the chip, cause I can't get anything to work. I'm totally new to this whole BIOS, FLASHING bit. I don't think I screwed up my xbox, cause there's no red lights flashing. Please tell me what I need to do, and please don't send me to some crazy faq's or forums, there to confusing as it is. I really need your guys input!!! Thank you for your time. infidel80**********com