DF: Landwarrior CD 1 for 1 copy

[Brother]

Delta Force: Land Warrior
CD COPY Instructions
(CloneCD Version 2.8.3.1)
(LG CD-RW CED9090B Hardware used)

1. Select "Copy CD"

2. "READ" file tab
- Select your burner as the reader
- Read Speed: set to Max
- Read SubChannel Data from Data Tracks checked
- Read SubChannel Data from Audio Tracks checked
- Fast Error Skip checked (with dialog box options set to their default)
- Intelligent Bad Sector Scanner checked

3. "WRITE" file tab
- Select your burner as the writer
- Write Speed: set to Max (unregistered CloneCD will burn at 2x)
- Don't Repair SubChannel Data unchecked (or shaded out)
- Simulate Writing unchecked
- Burn Proof/Just Link unchecked (or shaded out)
- Perform Laser Power Calibration unchecked
- Wait until Buffers are full unchecked
- Always close last Session checked

4. "GLOBAL" file tab
- File Buffer Settings set to Default

5. Select "Start Disk Copy"

6. When reading is done, eject disk and put in an 80 min CDR for writing

Comments:
You'll notice the progress bars will not load and no estimated time will
show. Time took approximately 2 hours.


You all didn't helpabrother out.. so I had to make a couple of coasters before finally backin up my shit. Hope this helps any of you.

- Brother Monk

[greyzone]

You are the man!!!!
I lost access to the mitsumi, so I cant use clone cd, as I have a Teac 55s.
Tried copying everything but the Terrains.pff and Dflw.pff, and then copied them from the installed game to my burn folder, and then they were no longer 2.5 gb!!! the game installs, and runs just fine until I start a mission, then it quits with a sysdump message:-(( tried reloading it 2-3 times, no go..
Got any ideas??? This has cost me 7 cds up to this point

[boombolinat]

same problem here- teac 55s
using nero

how to burn this game?