|
#1
16-10-2003, 08:07
|
|||
|
|||
Think My Laser is Shot
I have a V4... can anyone give me some pointers as to what to do.
I'd like to replace it myself, if its not as hard as doing a mod-chip, I'm not that good as soldiering small joints. Maybe someone can give me a good person to repair it in the PA, NY, NJ area. Thanks Pepe 
|
| Sponsored Links |
|
#2
16-10-2003, 08:28
|
||||
|
||||
|
Replacing the laser is a simple job. Anyone can do it. Nowhere near as difficult as fitting M2.
The only soldering u have to do is to remove two solder links on the laser unit when u get it ( antistatic precaution solder links) Once thats done all u have to do is strip down the dvd drive a bit an drop the new laser unit in. It should work straight off without any adjustments. Regards
__________________
Zap Brannigan quote - "You remind me of a younger me Fry, Not much younger mind, perhaps even a little older."
|
 |
|
|
Linear Mode
