Daemon tools question?

[Serhat]

I can't designate a drive letter to my virtual drive on Daemon is there any way to fix this without formatting ?

[DABhand]

Sounds like something is blocking it, or it didnt install correctly.

[Joe Forster/STA]

What exactly are you doing/trying to do (click this here, type in that there) and what exactly happens/doesn't happen? Most probably, you're just not doing it correctly. By the way, have you read the docs/help?!

[Serhat]

I've read the doc.

for what I do... just right click on the icon while it's in the thingie Right down of the corner, it's on the tip of my tongue.. can't get it out..

just right click there then going with the mouse to virtual cd/dvd rom then Device then set device parameters. after that you get a screen where you can choose a drive letter, but none is accepted.. there is the daemon tools loading thingie sometimes it goes for a few seconds sometimes barely noticable but no drive letter is accepted and I can't figure out why

any help would be greatly appreciated

and for the installation part, I've downloaded installed uninstalled on so many times and got Daemon tools from different sources.. but to no avail.

----- Bus Number 0, Target ID 0, LUN 0 ---- this is listed when I go to device properties for the virtual drive, I'm not sure if this is good/bad ?

[Am Shagar]

Go to "virtual cd/dvd rom", then to "Set number of device" and choose 1 or what you like.

Yours seem set to disable.

[Serhat]

Originally Posted by Am Shagar

Go to "virtual cd/dvd rom", then to "Set number of device" and choose 1 or what you like.

Yours seem set to disable.

that's the problem, I've set it to 1 but it still sais 0 after Device where I'm guessing it should be 1.. it doesn't matter if I change to 2 or 3 virtual drives.