Duo2se on v7 problem

[s3m5]

Hi, ive recently installed a duo2se on my ps2 v7, but there is no signal comming out from the video output of the ps2. Can someone help me and tell me whats was my error in the soldering?

thx in advance.

[lufcfan]

Black screens are common of solder splashes on the motherboard - but the biggest cause is the bridging of the pins on the BIOS chip. On your mod, check the pins aren't bridged on wires P,O,N,M,Q,T,U,V and R.

Hope this helps my friend, good luck - and keep us informed

[spedmetal]

yupe check over your install very carefully. doesnt take much to get an error like this and like lufcfan said the problem is normally something being bridged or grounding out when it shouldn't be. Look for pinched wires as well as make sure the wires are going to the right place. Also you might try disabling the duo2se to see if you can even get the PS2 to boot up at all. Good luck, keep us posted.

[pstwomods]

Try each wire solder carefully, make sure you hold it up right.

[Warlock]

Originally Posted by pstwomods

Try each wire solder carefully, make sure you hold it up right.

Hold what up right

[pstwomods]

Originally Posted by Warlock

Hold what up right

I mean soldering it right

[spedmetal]

Originally Posted by pstwomods

I mean soldering it right

errr umm err yeah .... I'm sure that never crossed his mind. Sheeeshhh who would have thought to "soldering it right". What a concept.

any way this is kind of an old post .... wondering why you .... oh never mind I know why.