|
|
|
#1
08-01-2003, 00:07
|
|||
|
|||
|
Fixing PS2 Question
I recently tried to install a no solder chip into my v4 ps2 and im not getting any power to the reset button at all. I checked to amke sure all the connections were tight and tried it numerous times. I eventually decided to just take the chip to check that i didn't mess anything up. The problem that i have no is that there is no power going to my reset/eject button. When i turn the switch on, I can hear the electricity in the system going on but the light, fan, and etc still dont work. Could it possibly be because of a broken ribbon or something else?
|
| Sponsored Links |
|
#2
08-01-2003, 05:49
|
||||
|
||||
|
Yes. It sounds like your reset/eject ribbon cable is damaged. Strip your ps2 down and put it back together very slowly and carefully and if still no joy then order new ribbon cable. I think they cost about £10
__________________
Zap Brannigan quote - "You remind me of a younger me Fry, Not much younger mind, perhaps even a little older."
|
 |
|
|
Hybrid Mode
