OK, I have the same Traxdata 8432+ as you (with v2.2) , with this spec:
Cyrix 333+(3.5x75MHz..yes, it's a slow one!).
Win98 v2.
150MB permanent swap file.
128MB PC-100 RAM.
20.5GB IBM hard drive: primary master.
24x Toshiba Cd-rom: secondary master.
Traxdata 8432+: secondary slave.
Nero 5.0.2.8......no luck with Dreamcast stuff, ok for rcacked PSX games.
CloneCD 2.7.8.1....Can do Dreamcast or PSX stuff at 8x!
Discjuggler 3.00.755 DTU....Can do self-boot Dreamcast stuff at 8x.
Here's a couple of important factors to note with my copying success:
1. My Toshiba will do a FULL RAW read; I beleive the Traxdata will not. Due to my copying success I beleive it does RAW writing - but to what extent I don't know (i.e. it may not burn ALL protection systems).
A quick fix therefore may be to look at CLonceCD's help file under Hardware Requirements, and purchase a cheap CD-ROM (ideally one made by Toshiba as they're recommended).
2. Try a different brand of media - there's always a minority of brands that just simply will not work well - Some Samsung discs play havoc with my writer. Still having trouble? Try a lower burn speed.
3. I think someone else mentioned this - chec_k your APSI layers. I use version 4.6. This is because some Adaptec sotware OVER-WRITES your ASPI layers, possibly with old/out-dated layers and hence you need to update your layers. I have the programs to both chec_k and update your layers if you wanna mail me. I can also post you a screen-grab of the boxes Iv'e chec_k ed in all my programs, to copy dics etc.
[email protected]
Good luck m8 :-)