Ok, I reopened my PS2 to make sure the single wire link was ok. According to the picture I worked off of at: http://www.modchip.ca/neokey.html version 4 diagram my install is ok. If you'll note the picture indicates that the wire should be soldered to the TOP part of the chip (figure A).
Now if I go to:
http://www.lik-sang.com/download/sbox/neokey_4.jpg
The same diagram indicates that it should be soldered to the BOTTOM of the chip.
My question now is which diagram is right, and does it make a difference if it's soldered to the top or bottom (or even middle?) part of the chip?
Thanks in advance, just dis-assembling my PS2 to this extent makes me cringe
