|
I recommend using the latest official version, 2.8.5.2. I would avoid using any beta version of Clone CD (ie, 3.0.x)
I'm nearly 100% sure your drive is compatible with Clone CD. When you load CCD, click on the 1st icon on the left (read to image) The best settings to use for MM2 (or any game protected by Safedisc) is to have fast error skip on. Next hit the icon on the bottom (Start Disc Read). It will seem to take forever the first 3 or 4% of the read, because this is where the Safedisc errors are. Usually around sectors 800(+/-) through 10,000(+/-)
It will speed up dramatically once it gets past the first couple of percent on the read. When it gets finished reading it, next you will want to write the image (2nd icon from left)....the only option to ##### (if it isn't defaulted) is Always Close Last Session. Now make sure write mode is set to RAW-DAO. Begin recording!
Some people will tell you to read and write at lower speeds than your burner is capable of. Personally, I always read and write at max speed and never have had a problem. I'm using 2 different burners (Sony CRX 160 + Philips 804K) from what you have though, so you may have to.
I may have left out some info that you may need, due to trying to recall this from memory. If you have any more questions, email me, or post again here, or try the CloneCD Underground forum @ www . elaboratebytes.com/eb/
There is lots of Clone information available there. Just click on the "Discussion Forums" button on the the top left when you get there.
:-) "BiG SWoLL"
|