|
I'm very new to directly interacting with Inno and am trying to start here. So I tried to add the razor stdio patch, some xtool libraries, and 7zdll by adding them to arc.ini, the definitions, and the 2 locations where those definitions are checked. I also changed the name of one of the disk file names in the adding disks section. When I run it, it hangs after unpacking the temp folder for about 25 seconds and gives me an error. This works just fine when unpacking it with my own FreeArc setup. The error code is -11. After changing everything back to what it was before and only using built in compressors, I still get the same error. Am I doing something wrong here?
Last edited by ozerune; 24-03-2024 at 18:09.
|