I'm working on a few new features for Ultimate Conversion Compressor (UCC), as follows:
- Error.log - Error log file will be generated during compression, if any error occur it will be completely outputed to the Error.log file, if no Error occur Error.log file will be deleted
- Optional Records.ini generating for CLS-Diskspan - for use with CIU v2.0.3.9 setups or in rare cases when Diskspan don't work correctly in CIUv2.0.5g
- Optional CIU v2.0.3.9 Records.ini generating - option to generate records.ini file even when not using Splitter option for use with CIU v2.0.3.9
More Info:
Error.Log
As described above, whenever an error occur during compression UCC will output the entire original error message generated by the compressor to a text file called
Error.log, this should make it easy to troubleshoot problems.
When compression ends without any errors the empty Error.log file will be removed.
This is actually an evolution of the previously mentioned feature I posted about in my last post in this thread (
see here).
Diskspan Records.ini
A new option in
Settings.ini called
SpanRecords is added, when enabled (set to "y"), UCC will create a simple Records.ini file for installation of CLS-Diskspan archives.
This is required for use with CIU v2.0.3.9 U11 or newer.
It also helps in occasions where CIUv2.0.5g causes Setup.tmp errors on Installation Cancel & Finish, if this is the case, use the option to generate the Records.ini file and use it instead of the [ExtractSettings] section of CIUv2 Setup.ini file.
CIU v2.0.3.9 Records.ini
A new option in
Settings.ini called
DatanRecords is added, when enabled (set to "y"), UCC will generate Records.ini file to be used with CIU v2.0.3.9 Setups.
The file will be created in the first disk folder after the first archive is created and will update with additional records after each additional archive is created.
This is only needed if the Setup you created was designed using CIU v2.0.3.9, make sure to disable the option if it wasn't created with CIU v2.0.3.9.
Please Note:
All of the above features are still being worked on & tested, if you want to help test them please send me a PM.
Have a nice day
