|
Hi there Razor. Its been long since I've used your software, because I was too lazy to read Help File. But in the end I did and it helped alot.
But now that I've went through ALOT to make a template... Got struggles man, some really bad ones.
Anyway, I'll tell you the struggles just after this.
I created a template with functions to extract 1x *.bin file which is 9.70gb in size. After that comes Shortcut, Redist, DirectX... And is works fine. BUT, after the extraction, after the shortcut and redists, the Finish page comes up, but when I click on "Finish" to close, it just hangs there. Tested a few times, and found that files are still being used by the setup.... Its still extracting files! I looked in the Install directory and files were still being created while setup hangs in finish page. (I have 6 pages, 5th page is the "Successful install" page, and 1 dialog just for asking "are you sure you want to stop installation?". Problem there?)
Is my *.bin file to big, should I split? Or problem could lie with compressing files with FreeArc?
As for the struggles, if I made too many changes in one template and then save, it would not save. Instead it would delete the saved template I want to override, and losing my template completely. I got around it after redesigning my template 5x over. Please look into it.
I've been using version 0065...
Thanx in advance if you read this and reply.
|