|
I have installed mod chips in every version of the PS2 and have never pushed any wire through the board and soldered it to the back. It is possible they know something i dont but i have never heard of this or seen this on any diagram. As tbwtk said pins 5 and 6 can be very difficult. If you are not 100% sure of yourself as far as the installation then i would get a experienced installer to do it. If you still want to try it then be sure to attach the chip in a secure,out of the way spot on the board using electrical tape. If you have a version 4 be sure the cover dont pinch the chip. Completely cover the chip with tape to be sure it doesnt ground out on anything. Be sure the wires are run along the board so they don't interfere with any of the cover contact points on the board.... Good luck wakim, I hope this helps.
|