Quote:
R-dude (17-01-2001 03:26):
what you can do is install a toggle switch inline on the (pos) pin
|
Accidentally made a new post. Anyways here it is
-----------------------------------------------
I asked how to explain and heres one of the replies I had gotten. Hope this helps.
------------------------------------------------
Just to add to spookys solution, you need only cut EITHER the wire at pin 1 OR at pin 8 as these are the wires that power the chip (1=V+) (8=V-), then put the switch in between the two pieces of the wire you have cut.
As I have tried to demonstrate below !!!!!
.......................\.......................... ......
to pin<_______|---|______>to spot on PCB
switch
------------------------------------------------