[oZER0o]

well you were being very vague, but i eventually found the romeo mod instructions.

3rd pin down from the corner the faces the center of the board, and connect that to a "VIA" on the inverse side, through the hole to the right. i have closeup pics. VIA's are the little round pads right?

so the idea is to lift the pin of the LA chip, right? the whole point is to replace the Vin with 5v1 from 12v right? So all i have to do is heat the base of the leg, and use a needle-nose plier to lift the leg? ive done this many times before, shouldnt be too hard, i have lots of trashed circuit boards in my house to practise on (but just 1 ps2 board).