[TarzanBoy007]

I stayed up all night shortening wires and looking over my installation and
I am having a different set of problems now.

-(I discovered that I had attached point B on the mod chip to the wrong point on the PS2 board)

Now, whenever i boot the PS2, it goes straight to the sony playstation logo (the red/yellow/green P), the PS2 name (neon blue), and then straight into setup. After I put in the language, location, and timezone, it gives a DRE.

I'm guessing that my problem is somewhere on the bios chip (the one with the alternating on-pin solders straight to a chip on one side and the little pad solders on the other side), so I'm going to check there.

Any advice/insight is much appreciated.