Rear Leutz! Because several inquiries came again in detail, how it mfunktioniert with Blindwrite and Alco-get and without emulation! I have Blindwrite version 4.25.35 and Alco-get is actually all the same which version. As the first take you Alco-get with the profile Securom 4/5 or something where ne DPM measurement thereby is and measurement stops quality to high and lasts at the best 1x, approx. with DPM. 10 min is then in addition, tidy quality. If the DPM is finished measurement and it begins the image to make, kannste breaks off clicks and with the question whether it the data produced so far to delete is, klickste no! Into the file where Alc the data puts down now off! There now 2 Datein, a MDS and a begun MDF haste. The MDF kannste directly deletes! Now Blindwrite start, attitudes 4x read, Nibbel and Subcodes select on! Is happened start you the BWA builder in the starting menu with Blindwrite with in it is! Click with this then on "Load BWA/MDS" and with Alc provides MDS loads. Now you have normally ne beautiful curve with few thicker blocks if everything smoothly went! So then only on MDS ton of BWA" "Convert; or is called so similar that click, which MDS select and you have a ne BWA file with the Blindwrite which begin now can! This BWA you take now, and live her into the file, where the 3 files of select sind(normalerweise C:\Programme\VSO\Blindwrite with Blindwrite in it) it is importantly, which you BWA file into exactly this file also clean-done where also the other image files are, because otherwise the physical data of the sector density are not written! Again Blindwrite start so now and burn. Amusing image examination and it would have all ok starts to actually be, except which physical data were found. Now further to the fuel attitudes: Write mode DAO PW 4x burning speed and completely importantly a hook with "Use BWA file if avaiable" clean-make, otherwise was the whole work for naught. The CD runs on all drive assemblies without Emu! So and if again one does not mean it now goes, has either which made for that wrong, or a bad burner and should themselves ne BWA somewhere download! I hope I could help?! In the sense much fun when burning!
