|
I have bought the plexor 12/10/32A
burner because it is said to
be excellent and i am only doing coasters.
I have installed forceaspi1.7 and finally
i could install dikjuggler 2
and i could only
burn with success one game: TOKIO.
I have also
installed
the jinxter ghost driver.
In summary i try to burn 10 CDs and i only
got success in 1 CD, i think that
is a very bad rate, i was tired of
my old generic obsolete cd-rw
6*2*2 because it was slow but with
this old one i have never
had any problem burning games
with dikjuggler 3 or any other software.
Now i have spent U$S 323
in this plexor cd-rw
and i am only throwing discs to trash.
I have configured diskjuggler as follows:
Mode 2
2336
cdrom
Raw: activate.
Karaoke: activate
And i have also tried to burn at 1x and the same result, the first tracks are
always recorded successfully but the
last track (about 1M) when it tries to write gives me
an error: event 17812 "(CDB: 2a000004aa e100 000a00, status: 040002, sense: 052400)
illegal field in
command descriptor block"
or something similar with different numbers.
It looks like it can not
write this last
short track properly.
I have also tried converting cdi image to nrg (nero), i have converted it
well but then when i try to burn it,
the proccess goes on normally then, burn proccess
completes and reaches the 100%
but then it gives me some error
messages
in red and the copy does not work.
I can not really understand it, i could with my
old
cd-rw overburn for example the cdi 80:30 image of
sould calibour and with this new
cd-rw i can not even burn well anything.
Please someboby help me.
Perhaps my cd-rw is damaged ?
On other hand, i have
also
installed winoncd 3.8 power edition but really i can not figure
out how to open and burn a cdi image.
This program let my only open cdj and c2d
project files but
i can not open cdi files.
Please can anybody explain me how to open, configure the parameters
and burn a cdi
image succsesfuly with this program ?
Thanks, good bye.
|