Well really i am getting very ungry.
I have bought the plexor 12/10/32A
burner because it is said to
be excellent and i am only doing coasters.

I have installed forceaspi1.7 and finally i could install dikjuggler 2
and i could only
burn with success one game: TOKIO.

I ahve also
installed
the jinxter ghost driver.

In summary i try to burn 10 CDs and i only got success in 1 CD, i think that is a very bad rate, i was tired of
my old generic obsolete cd-rw
6*2*2 because it was slow but with
this old one i have never
had any problem burning games
with dikjuggler 3 or any other software.
Now i have spent U$S 323 in this plexor cd-rw and i am
only throwing discs to trash.

I have configured diskjuggler as follows:

Mode 2
2336
cdrom
Raw: activate.
Karaoke: activate

And i have also tried to burn at 1x and the same result, the first tracks are
always recorded successfully but the last track (about 1M) when it tries to write
it gives me an error: Event 17812 "(CDB: 2a000004aae100000a00, status: 040002, Sense: 052400) illegal field
in command descriptor block"
or something similar with different numbers.
It looks like it can not
write this last
short track properly.
I have also tried converting cdi image to nrg (nero), i have converted it
well but then when i try to burn it,
the process goes on normally the, burn proccess completes and reachs the 100% but then it gives me some error
messages
in red and the copy does not work.

I can not really understand it, i could with my old cd-rw overburn for example the cdi 80:30 image of sould calibur and with this new
cd-rw i can not even burn well anything.

Please someboby help me.

Perhaps my cd-rw is damaged ?

On other hand, i have
also
installed winoncd 3.8 power edition but i can not figure
out how to open and burn a cdi image.
This program let my only open cdj and c2d project files but
i can not open cdi files.
Please can anybody explain me how to open, configure the
parameters and burn a cdi
image succsesfuly with this program ?

Thanks, good bye.