[webber]

yes you really only need one set of settings to get it right, in my opinion the settings that you use are wrong but others would disagree which brings the point up that different settings for different burners.
in my opinion mode 1 should only be used if it is non self boot again there may be disagreements so here goes on what i use and what has given me zero coasters always,

now these are what i have used for all self boots--->use dj
for non self boots they are usually bin/cue -------->use fireburner

for dj3 with the jinxter ghost driver (this driver made all the world of difference for my burner)
mode2
cdrom
2336
check the write raw
check the karaoke
uncheck the pregap one

do a test to see if no red flags pop up if none just change it to write
burn at 1x or whatever you want i always burn at 1x i just set my computer up and do other work on it or use my laptop while it is burning (it usually takes about 1 hour 15 min)

the key is to make sure that the software can handle multisession

regards
webber