Ok, i had my dms3 v2.0 installed in my v7 but it was sloppy so i decided to take all the wires up and do it over, well when i was takin off the wires on the backside of the board wire r decided not to come off. It ripped the copper solder pad thing off with it, along with the copper strip that goes back to the hole. Heres a pic but its blurry and out of focus if you dont know what im talking about. It ripped off from the arrow the other arrow.
What should i do to fix this, i was thinking i could just solder a 30awg kynar wire from the really small hole to the copper solder pad and it would be fine. What do you think, and how should i fix this?
What will not having this on do to my ps2???
This sucks and i was planning on having the install done tonight but so much for that, thanks for any and all help guys.