Need help on AppleX3
 

I have a xbox version 1.0. I follow the soldering guide from apple site. Everything looks good but I still can't get the mod to work. Is there a way to tell if mod working without having to keep resoldering again and again.

how did you solder? Do you have an on/off switch, or did ou solder it to turn on/off with the eject/power button?

If the chip is on, I believe it has a different colored X logo when it starts up. If it isn't pre-flashed, then it should boot to a cromwell, blue screen.

what version xbox do you have?

I have xbox verson 1.0...I solder the mod right on the board...and the 2 wires..1 to point A and other point B. When i turn on the xbox still in original bio...tryed using the power button and eject still the same. 1 question...do i need to flash the mod or is it ready to use? Thanks for the advice in advance.