D0
 

Hey,

i am just wondering if this d0 is preped enough i will attach the picture later.

Oh and can i have some soldering tips.

here are the links

http://homepage.ntlworld.com/teresa....m/DSC00190.JPG
http://homepage.ntlworld.com/teresa....m/DSC00198.JPG
http://homepage.ntlworld.com/teresa....m/DSC00201.JPG
http://homepage.ntlworld.com/teresa....m/DSC00202.JPG

thanks
seaneyb

hehe
u just replied to urself

yea,
take a look at the pics and zoom in to the d0 point and see if its all ok

those pics kinda suck..
can u get better ones?
try takin the flash off

ohhh there good ones.

i try but its a pain keep undoing the xbox.but dcs201.jpeg you can see the d0 point fine.

Hello can someone tell me if the d0 point is preped enough?

how can i solder onto this git!

dude calm down
u ask soo many of the same questions
just give it a shot

yea
i dont rely on the top d0.

give it a shot and let us noe how it goes

im gonna do the bottom d0 next week sometime i got to get lots of equipment wire solder flux desoldering braid tip cleaner! wire strippers!
hehe anyone know where i can get cheap wire stripers i seen em but there very expensive.

The top D0 looks fine. Its not as hard to solder to as people make it out to be.

What I've found when I do X2 installs is the D0 wire is just small enough to fit in the D0 hole it self. Put the wire in the hole and heat it up. Since the wires are pre-tinned the soldering iron heats that up and the solder flows into the hole making good contact.

hey,

what chip you reccomend me getting then? a duo or a x2 lite?

o my god
come on seaney... dammit!
just go with an xbit or an x2
its been sooo long already