FileForums - Hitman safedisc 2

Hi ALL
I have backedup hitman (Safedisc 2??) with CloneCD (registered copy, version 3.0.0.20) using the Mirai BP1300 (firmware was upgraded from 1.0 to 1.06) drive with the following settings:
I used "copy CD" using ONE drive

1.Read Subchannel Data from Data Tracks
2.Read Subchannel Data from Audio Tracks
3.Fast Error Skip

reading took about 46 minutes

Then the data was written on the same drive with:

1.DAO-RAW (Disc-At-Once RAW)
2.Don't Repair SubChannel Data
3.Burn Proof

burned in 8 minutes. The game was installed via the mirai drive, but would not run on my PC due to poor spec!. Anyway it was run on my other PC using a plextor 12/10/32A drive AND worked and has been play with out problems for a couple of levels. Now will investigate until end of game. Clearly is READ on both drives).
AND WORK AND CAN BE PLAYED!!!!!!!!!!!!!!
So!!!! can you copy SD2 with CloneCD?

Background the Plextor drive (firmware 1.07)up DID not work in fact clonecd stated" that it CANNOT read subdata and did not ####t. However, I had uninstalled the plextor tools, I have heard that this may be a problem?).

Finally please Help: cloneCD stated that the Mirai BP1300 cannot read cd text, please fix it can an confirmed by mirai. Also clone cd states that the drive can do:

Best Supported Write Mode:RAW-DAO 96
Best supported Read Mode for Data:RAW
Best supported Read Mode for audio:RAW+96

Can ANYONE!!!! confirm this also anyway to ##### if The BP1300 can do RAW+96 in read mode for data and audio? (#####!! mirai website for info on firmware)

thanks

fishking