CLONECD AND HP 9100
 

i HAVE AN HP 9100 AND I CAN`T BURN ANY RENTED GAMES WITH CLONE CD THE OPTIONS I USE ARE
READ READ SPEED 1X
READ SUBCHANNEL DATA FROM DATA TRACKS
READ SUBCHANNEL DATA FROM AUDIO TRACKS
WRITE WRITE SPEED 1X
DON`T REPAIRE SUBCHANNEL DATA
ALWAYS CLOSE LAST SESSION

AND I CAN`T BURN ANY THING PLEASE HELP

You have to make sure that your burner or reader can actually read sub codes there are few burners that can do this(Three that I know of)Plextor,Yamaha,and LG.Hope this helps!

I have an HP +9100 (I believe it's a 9103 to be exact) and it can use CloneCD just fine...Reads sub-channel data and burns images perfectly. Unfortunately, I have no advice for you, looks like you've got all your settings correct. When you say you can't burn anything, what happens? Do you get an error?? Be specific please.

Mike

Where do you get your games ? Blockbuster !!

I have the same problem clonecd doesnt seem to with my HP9100.

I have a hp 9100, and it works fine, except for safedisk 2 games, in which case itll burn it, you can install it from the burnt CD, but you cant RUN it from the CD. you have to crack it.

He burner : hp 9100 is a very good writer , the problems is useally the settings off cloneCD also the versie of cloneCD can make some difference i had only problems with versie 30011 i update this to 30014 and this versie is good also older cloneCD are good,use for the settings clony or copy protection detection ,these programz pass the params to cloneCD.
Sorry for my bad englisch
Jac.