Charlie Origa pin Q3
 

Charlie did you wire in pin Q3 to your pal version 5 board as I can't seem to find any details about it from the origa web site.

Is it just not used :confused:
and how do you know which pin is Q1 and which pin is Q2 the diagram is not very clear, one side of the component has some numbers on it can you tell from that side


Thanks in advance

Q3 goes to a GROUND point. M is also a GROUND point if that helps.

Q1 and Q2 can go either way round. The Cap is not sensitive as to orientation.

Hope that eases the problem for you.