To charlie
 

sorry dont wish to be a pain but are you still going to send the origa 1.12 english instructions to me version 4

cheers

Sent it last night. Didn't you receive?

no didnt recive any thing but it could be my email account i have blocking alot of accounts
so if u could send again i have opened a new email account danielaussie2**********com which has no one blocked
thanks for all the help
cheers

Just sent. It's 1.6MB!!

i have no idea whats going on but i didnt recive it again i just found out that my email accounts only take 2 meg so that might be the problem
so i opened one that takes 6 meg so if you would not mind trying again to send it again,to this email account danielaussie********com
and im very sorry about all this trouble
cheers

will do some time this weekend.

thanks for all this, lets hope it works this time
cheers

Resent 09:00 today. A local installer modded a 15000 on Saturday with these destructions. Worked OK. Remember you'll need .1mm tip, 28 swg laminated copper wire; two razor blades to go between the pins when soldering.

i got them thanks heaps
two questions 1 will they be fine on the version 4 pal board
2 how do i open it ive downloaded them doubleclick the file and new window comes up which says open with and i have no idea what to open it with

Ahh - it's for a PAL system. I should have read your first mail more closely. There was a v1.12 for JAP and I didn't notice your version 4 statement. Sorry. The stuff I sent is strictly JAP 10000/15000. the boards are different. You'll need to take the diagrams from the www.origachip.com site for v4 PAL. I'm sorry for causing you delay.

To read what I've done, you'd need the Adobe Acrobat reader.

The CPU pins are the same as between JAP and PAL PS2s but the location might be different.

ok thanks for the help