gce-8320B, HHHHEEEELLLPPPP!!!!
 

I just bought this cd burner, am trying to burn Comanche 4 which has SD2, dummy files, and over burn. I down loaded the clonecd 4, and ClonyXL, With CloneCD 4 it does not give me an option to burn Raw DAO. Will this matter?
I tried to copy it and it does not work??? I thought this cd burner is suppose to be able to burn it? HHHEEELLLPPP, please... Thanks Russ

Overburn? Is the CD bigger than 650MB? If so id use a 700MB CD-R.

If there is no option to burn RAW-DAO, then it's likely that ur burner doesn't support this mode.

Huh?
The 8320B is said to be THE writer when it comes to cloning.
Now im a little confused :confused::confused::confused:
Is it really that good or is it crap?

try finding a link to see you burner's capabilities....

CD Burners GEC-8320B...
 

I got the information to buy this burner from inside here at this forum. It is suppose to be able to copy sd2. So, now what??? what capibilities do you want me to look up???

still need help or info
 

I still am looking for help to make a perfect copy of comanche 4. I have GCE 8320B liton it is compatible. I do not get a chance to change settings in CloneCD 4. Anyone know why or what I can do. Thanks for the help. :confused:

The 8320B is not a LiteOn drive. It's an LG (Lucky Goldstar)
I've seen conflicting reports about whether or not it actually burns SD2. It may have something to do with the firmware.

firmware
 

can you change the firmware? if so how? how do I check which one I have? Thanks :(

go to the control panel to check the version......you can download new firmware from the company's site....

gce 8320B
 

Thanks for all the help. I have been able to copy comanche 4. It can copy sd2, I had to change my region in my computer as I am In the USA, to get clonecd to work. And use clony XXL, So, the information on the Forum is accurate as to what can copy sd2 and what is compatible with clonecd. Thanks again, :D

god-f*ing-damnit, why did you post the same thing at the bottom of 5-6 threads?

Getting help
 

Sorry, about that. I just wanted make sure that the threads were all answered. They all have been. Sorry, if I caused a problem in that area. I will not do again... I had a couple of different problems and with the help of everyone in here; I was able to find out what I needed and copy what I was trying to copy. Again, sorry... and yet... thanks for the help. :)

sorry too, its 4 am, and i read the same post 5 times because it was marked *new*

tell it once and we will understand....

LMAO

nfuwmfbymfsamfgcoiwfu!!!!!!!!i really made a phrase with these!