Talking about laser-exchange: got a V7 with wornout 400C-laser as well. Is it possible to install a new one for anybody or is that a very complicated procedure that should be done by an expert? Read the UI-Sticky-thread about laser-calibration, but didn´t look too difficult, and am not sure if this needs to be done with a new laser?

Need advise again :o
Do only v4's have the warning logo on bottom of PS2 :confused:
If so the guy I got the v7 last night just changed label on back :mad: , as it had the warning logo on bottom of PS2 . Should not have done if it was a good v7 Right ?

:D

No, also the V7s have the warning logo! My one definately is a V7 (GH-019 Motherboard, KHS-400c laser, SCPH-39004 PAL), it has got it! Seems he didn´t change the label, Bionic_Man.

My SCPH-39003 has too :)

Warning logo on back is Cool :) ,
It's just that I read that only v4's had this logo


Thanks

;)

nope v3s didnt have the label on the back 4 upwards do.

Never install a new laser without calibrating it. IMO it should be done by a expert.