messiah 2 install bios point question (not relevant to the other one)

[Seven O Two]

i find it easier to install to the copper pads than the actual bios itself... is it possible to connect the wires that are supposed to go to the bios legs itself, to the copper pads on the underside of the board?

i figure the copper pads are there in direct relation to the bios chip, i was wondering if that would work

[charlie_ps2]

With Messiah 2, which is not BIOS wire length sensitive, yes. Just meter the pad and the leg to map it out.

[Seven O Two]

sweet, thanks charlie