for charlie

[kidace]

tks for response,
hope to hear from dal umm you told me i have a ver four i will tell dan where you told me to go get diagram so he can look at it wanted to ask one more time so i can tell him
on the back it say model is 30001 but it is not a ver 1, 2, 3, because the serial starts with a u4 so that means it is a ver 4 right.
also once i know that i did not see a dvd x key
diagram so do i tell him to follow the neo 2.2 5 wire diagram since they are pretty much alike.
tks for all your help

[Charlie]

Woodmaster recently posted these NEO2.2 pinouts that may be helpful to your installer:

There are two ways to install the neo2.2, a 5 wire install which doesn't support the ea boot method and the 8 wire install. If you have the 8 wire install and the tray wont open after holding reset for 10 seconds then the install is dodgy. Like charlie stated pins 5 and 6 crucial. here's what each pin controls
PIN #1 = supplies + (power) to the chip
PIN #2 = sends SCE signal out to PS 2
PIN #3 = PS 2 drive tray pulse tells the BA5810FP chip whether to expect a drive tray open or close
PIN #4 = checks/signals RESET button on the PS 2
PIN #5 = closes PS 2 drive tray
PIN #6 = opens PS 2 drive tray
PIN #7 = checks if game CD is PSX/PS 2 (If PS 2, immediately stops SCE signal & restarts when a "tray close" is seen. If PSX, it stops after about 15-20 seconds)
PIN #8 = supplies ground to the chip