PDA

View Full Version : Executor2

suggy
13-02-2003, 13:25
Tryed to install Executor2 mod chip.

All that happens is , Beeping several times followed by red and green flashing light?

Any idears?
Quall999
13-02-2003, 13:57
Check yout solder points, or re-install it. That ussually happens when one of your soldering points are not touching the board completely.
What'sit
13-02-2003, 20:47
The chip may also be shorting out against the case check that also. Which do did you use top or bottum?
suggy
14-02-2003, 00:59
Dont think any off them as i allready have a Evox chip installed (on pins)
xxlenigma
14-02-2003, 04:07
See thats why I would like to get a premod xbox because I mite mess something up in there :(
suggy
14-02-2003, 04:35
Havent messed up,
The chip (EvoX) works fine,
Just want some thing better,
Chip may be faulty its going back for a replacement
AXmichigan
14-02-2003, 13:02
yea the same crap happened to me
im gonna resend it back
i just needa getta chance too....
im way too tired to do anything nowadays
i got mine from extreme-mods
...
accordin to www.xbox-scene.com it means that its a bad chip/bad image
suggy
15-02-2003, 01:48
Mine from DIVINEO Electronics Manchester
AXmichigan
15-02-2003, 18:21
i take it thats from UK
mines from the states...
so yea..
just send it back...
thats what i did
it better work wheni get it back
suggy
16-02-2003, 04:45
I good old UK

It better work or the S**T will hit the fan
AXmichigan
16-02-2003, 09:50
i agree
some major @$$ kickin if it doesnt work when it comes back