PDA

View Full Version : Neo2.5 DVD tray won't open and blue light are gone

XtraLongshot
27-01-2002, 13:10
HELP!!!!
I just installed the 2.5 dvd on my ps2 V5. tested with the case open it work fine. then when i put it back together . the tray it will not open and the blue light are gone. and the screen is blank.I checked with the board and all the ribbon connection, it all connected properly. the only problem it seem to be is no power to the drive . but when the system is on standby mode and I press the eject button the system go on but the tray won't open and nothing on screen. please help me asap. thanks
VolitileVole
29-01-2002, 03:23
Hey i was planning to install one of these in a V5 board, let me know how you get on.

Onlything i can say double check all cables, and power conectors, if it still does not go it could be a fuse. Test them with a mutlimeter.

Sounds duff though :(
Arakon
29-01-2002, 04:57
also check if you possibly damaged a cable when you put it together. check especially near the edges and shielding.
XtraLongshot
29-01-2002, 10:06
Checked with all the cable still no go. where is the fuse located ? i only see one on the power board
Prototype
29-01-2002, 18:57
Does it work if you temporarily disconnect the pass-thru cable on the neo and connect the power/eject cable directly to the board again?
dust2dust
30-01-2002, 00:18
if it worked before u put it together it sounds as if u must damaged cable silver foil reset cable prone to breaking
Nincat9
11-02-2002, 20:33
I have the same problem ....the eject button won't work....but mine is a version 4 and i followed all the instructions on soldering....the eject button just doesn't light up

I tried switching the silver cable with another one ...but it still doesn't work....any there anyway to make the tray eject maunually?

I hope I didn't break my PS2....cause there is nothing on the screen when power it up....just flickers once when i power it up..

Please help if you can
Thanks

-Nincat9